Heating and cooling technician servicing an outdoor condenser unit in Whittier, CA

Heating · Cooling · Air

Trusted HVAC contractor in Whittier, CA

Cooling that holds through an August heat wave, heat that arrives on the first cold morning, and ductwork that stops quietly wasting both.

ClearHearth is a Whittier heating and cooling company working on the systems inside real houses — bungalows with shallow attics, ranches with original duct runs, additions that never got their own zone. We repair, replace, tune and balance, then explain what we found in language that makes sense.

Request a visit

Name, number and a line about the system. The office calls back with a real arrival window.

Prefer to talk? (562) 687-2050 · 07:00 AM - 08:00 PM

Hours
07:00 AM - 08:00 PM
Based in
Whittier, CA
Response
Same-day windows

8

Services under one roof

7

Days a week, 07:00 AM – 08:00 PM

5

Neighbourhoods served

1

Team you actually reach

01 — Why ClearHearth

Three things we do
differently

Every company says it answers the phone and shows up. These are the habits that actually change how a system performs a year later.

More about how we work
01

We diagnose before we replace

Every visit starts with measurements: airflow, static pressure, electrical draw, refrigerant charge. That sequence finds the actual failure instead of swapping parts until the symptom disappears. You pay for a diagnosis, not a guessing game.

02

Local streets, not a call centre

We work Whittier neighbourhoods every week, so we know which blocks bake in the afternoon and which attics leave no room for a standard cabinet. That local knowledge changes the recommendation, not just the drive time.

03

Findings written down, plainly

You get the results in plain language, with photographs of anything we found and a note about what can wait. No pressure to decide on the spot, and no jargon standing in for an actual answer.

02 — What we do

Eight trades, one
comfort system

Heating and cooling is not one job. It is refrigerant, electrical, sheet metal, airflow and controls working together, which is why a single weak link can make a whole house feel wrong. Here is the full list of what we handle — pick the one that sounds like your week.

05 — Straight answers

Questions Whittier
keeps asking

These are the ten questions that come up most often on service calls and over the phone. If yours is not here, the contact page reaches a person, not a queue.

Most homes do best with two visits a year: cooling in spring, heating in fall. Homes with pets, heavy dust or year-round heat pump use may need more frequent filter changes between visits.

A well-maintained furnace often runs 15 to 20 years. Short cycling, rising gas use, rust in the cabinet and repeated repairs in a single season are the usual signals that replacement is worth discussing.

Ice usually means restricted airflow or low refrigerant. A clogged filter, closed registers, dirty coil or failing blower can all cause it. Turn the system off so the coil can thaw, then have airflow and charge checked.

The first heating cycle of the season burns off dust settled on the heat exchanger, and the smell usually fades within an hour. A persistent smell, or one that appears mid-season, deserves a prompt inspection.

Uneven temperatures usually trace to duct design: undersized runs, long flex duct, closed or missing dampers, or a return path that starves upstairs rooms. Balancing airflow is the first step before considering zoning.

Common causes are a dirty filter, frozen evaporator coil, low refrigerant charge, a failed capacitor or a compressor that is not starting. Each has a different fix, so the system should be tested before parts are replaced.

Size comes from a load calculation using square footage, window area, insulation, ceiling height and sun exposure, not a rule of thumb. An oversized unit cools fast but leaves the house clammy and cycles harshly.

Check it monthly. A one-inch filter often needs changing every 30 to 90 days; thicker media filters last six months to a year. Pets, remodeling dust and open windows shorten that interval considerably.

Yes. A standard heat-cool thermostat switches between modes, and a heat pump thermostat also controls reversing valve and auxiliary heat. Wiring must match the equipment, which is why replacement thermostats should be configured by a technician.

Repair makes sense when the failure is isolated and the equipment is otherwise sound. Replacement is worth weighing when repairs stack up, efficiency has dropped or parts are hard to source. We explain both paths honestly.

Still deciding? Send us the details or read how duct leakage shows up in older homes before you call.

Ready when you are

Something in the house is not keeping up.

Tell us what you are hearing, feeling or smelling, and we will put a technician on it — with a real arrival window and a plain explanation of what the system needs.

Call now

(562) 687-2050

07:00 AM - 08:00 PM · Seven days a week

Call now